How To Measure

For the person being measured:

1. Person being measured should wear a swimsuit, women should wear the same type suit they wear when diving
2. Stand straight, legs slightly apart
3. Face straight ahead, keeping your eyes and head level. It is important that you not look down, as it will create an error in some of the measurements. This is a common cause of measurements not being correct and cannot be over emphasized. Look straight ahead!
4. NOTE:  If you wear your boots under your suit you must measure with your boots on!

For the person doing the measuring:

1. Arm and leg measurements should be taken on dominant side. Please note that many of the measurements connect from one point to the next. You can leave one end of the measuring tape in place and advance to the next measurement. Measuring tape should be snug, neither loose nor tight.Contact us if you have any questions on a measurement or anything else.Take the time to actually mark the measuring points on the body. This can be done with a felt tip pin, masking tape, or chalk. One very important point to mark is the proper crotch point / Inside Leg. Having the person being measured hold a magazine between their legs where it fits comfortably in the crotch does this. Then place another magazine horizontally across the first magazine, holding it perfectly level. At the point where the second magazine intersects the upper leg, make a dot. This dot will designate the crotch point. It is extremely important that the person be standing straight while this point is being determined. 
2. The rule of "measure twice, cut once" should be strictly followed.

KH Boddy height BU Bust / Chest TU Waist STL Outside leg HU Hips SCHR Inside leg